Your system has a malfunction and the LEDs on the control panel indicate the malfunction.
Meaning of fault codes LED display in the control panel
• Elevation encoder fault during folding: LED1
Check the motor cable
• Elevation encoder failure during folding: LED2
Check the motor cable
• Antenna does not reach Azimuth limits within max. Required time: LED1 + LED2
Check that there are no obstacles against the antenna
• While searching, if azimuth switch of 0 ° detection is not found: LED3
Check the motor cable
• While searching, if azimuth switch of 360 ° detection is not found: LED1 + LED3
Check the motor cable
• During search, if elevation switch of 0 ° detection is not found: LED2 + LED3
Check the motor cable
• During search, if elevation switch of 180 ° detection is not found or if the motor cable is defective: LED1 + LED2 + LED3
Check the motor cable
• LNB or coax cable is not connected or defective: LED4
Check if the coaxial cable from the LNB is connected
• TVA 80 Premium antenna, sensor print or GPS sensor is not connected or defective: LED1 + LED4
Check the motor cable
• Azimuth motor encoder fault: LED2 + LED4
Check the motor cable
• Azimuth overcurrent protection: LED1 + LED2 + LED4
Check that there are no obstacles against the antenna
• Elevation overcurrent protection: LED3 + LED4
Check that there are no obstacles against the antenna
Note:
When the key switch (blue cable) is activated, the antenna collapses and the control panel gives an alarm 3 times
If the ignition switch is activated and the Standby button is pressed, the antenna remains closed and the control panel gives an alarm 3 times.
