You have connected a new receiver (or TV with built-in receiver) and R6 does not power up

You connect a completely new receiver (or TV with built-in satellite receiver), and the R6 system does not start up.

Some satellite receivers have the property that if the channellist not is installed, no LNB voltage is delivered. this LNB voltage is needed to power up the R6 antenna.

You have 2 options:

Connect the receiver and read channels to any other existing satellite installation and then connect to the Travelvision R6.

Or

Switch on the receiver, start the first installation of the receiver.
search channel list satellite (the receiver sees no satellite, and will of course not read any channels, but now sends out LNB voltage)
You will then see the operating module of the Travelvision R6 light up.
Align the Travelvision R6 on the satellite.
Then after aligning and removing the control module, start the first installation of the receiver again to install the channels.
You only need to do this once, the channel list will be stored, and LNB voltage will work properly.